 |
|
|
Home>New Products>ES-Tracker
| ES TrackerTM |
 |
| Conveyor belt emergency stop, pull-key monitoring system |
| Don't waste time walking conveyor belts to locate activated pull-key boxes. Use ES-Tracker! |
- Continuously monitors the emergency stop (ES) switches along your conveyors.
- Easily retrofits most conveyor pull-key (or pull-cord) ES systems.
- All digital components and addresses; No analog drifting or calibration nuisance.
- Add pre-start warning throughout your belt systems.
- Telemetry modules install easily in each of your existing pull-key boxes.
- High-speed data bus transfers via DX-Bus to the central controller at the belt drive
- Interconnects all pull-key boxes with a single 4-conductor cable (+/-V, +/- Com)
- Monitors and displays any number of individual pull-key switch units on any lenght belt.
- Use as stand-alone monitoring and display system, or interface to your belt PLC controllers
- Uses standard OPC interface to transfer active all ES addresses to A-B central station.
- High-speed communication data rates at 19.2KB; Fast response.
- Easily retrofits most existing emergency stop hardware.
- Displays all activated ES pull-key switches locally at the belt drive and/or on the surface.
- Economical; Generates fast payback from improved conveyor up-time.
- Can be expanded to include even add CO monitoring for your belt line.
|
Complete mine-wide monitoring systems can be supplied, encompassing all
your emergency stop switches, as well as atmospheric monitoring for carbon monoxide,
methane, oxygen and air velocity.
For more information on these and other fine Rel-Tek products:
Minesafe Electronics (W-KY,IL,IN)
Everywhere else, phone Rel-Tek direct
|
800-523-1579
800-783-9228
|
|
|
